Download  Print this page

Overview; Port Adapter Overview - Cisco PA-2FEISL-TX Installation And Configuration Manual

100base-t fast ethernet/isl port adapter.
Hide thumbs

Advertisement

Overview

This chapter describes the PA-2FEISL port adapter and contains the following sections:

Port Adapter Overview

The PA-2FEISL, shown in
for the VLAN transport over switch-to-switch backbone connections or switch-to-server data center
attachments. These port adapters provide an inter-VLAN bridging and routing functionality that network
administrators can use to deploy 100-Mbps Token Ring VLAN transport, 100-Mbps Ethernet VLAN
transport, and bridging or routing between the mixed LAN types using the same physical ISL trunk links.
Both full-duplex and half-duplex operation are supported for the PA-2FEISL. See the
Overview" section on page 1-2
Both models of the PA-2FEISL (PA-2FEISL-TX and PA-2FEISL-FX) are shown in
Figure
Although the VIP2, and Catalyst RSM/VIP2 support online insertion and removal (OIR), individual
Note
port adapters do not. To replace port adapters, you must first remove the VIP2 or Catalyst RSM/VIP2
from the chassis, and then replace port adapters as required.
Cisco 7100 series, Cisco 7200 series, and Cisco uBR7200 series routers support OIR of all port adapter
types.
OL-3475-02
Port Adapter Overview, page 1-1
Fast Ethernet Overview, page 1-2
IEEE 802.3u 100BASE-T Specifications, page 1-3
LEDs, page 1-4
Cables, Connectors, and Pinouts, page 1-5
Port Adapter Slot Locations on the Supported Platforms, page 1-7
Identifying Interface Addresses, page 1-9
Figure
1-2.
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
1-1, provides two 100-Mbps, 100BASE-T Fast Ethernet/ISL interfaces
for additional information.
C H A P T E R
"Fast Ethernet
Figure 1-1
1
and
1-1

Advertisement

Table of Contents

   Related Manuals for Cisco PA-2FEISL-TX

This manual is also suitable for:

Pa-2feisl-fx

Comments to this Manuals

Symbols: 0
Latest comments: