Cisco PA-2FEISL-TX Installation And Configuration Manual page 56

100base-t fast ethernet/isl port adapter
Table of Contents

Advertisement

Checking the Configuration
5 minute output rate 0 bits/sec, 0 packets/sec
Note
For the Cisco 7206VXR and the Cisco 7206 router shelves, the show interfaces command requires a
shelf number in the format show interfaces type shelf number/port adapter slot/interface.
The Fast Ethernet interface port adapter is numbered as port adapter 4. The Fast Ethernet ports on the
PA-2FEISL are interfaces 0 and 1.
VIP2 in Cisco 7000 Series or Cisco 7500 Series Routers
Use the show interfaces type slot/port-adapter/port command, with arguments such as the interface type
(for example, fastethernet) and the port number (slot/port), to display information about a specific
interface. The following example of the show interfaces fastethernet command shows information
specific to a Fast Ethernet interface on the PA-2FEISL in slot 3:
Router# show interfaces fastethernet 3/0/0
FastEthernet3/0/0 is up, line protocol is up
Hardware is cyBus FastEthernet Interface, address is 0010.5493.9860 (bia 0010)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Half-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:07, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
4-12
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets, 0 restarts
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 15654 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
27784 packets output, 2742738 bytes, 0 underruns
50 output errors, 0 collisions, 3 interface resets
0 babbles, 50 late collision, 119 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Chapter 4
Configuring the PA-2FEISL
OL-3475-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-2feisl-fx

Table of Contents