Chapter 3 Removing And Installing The Pa-A2 Atm Ces Port Adatper; Handling Port Adapters - Cisco PA-A2 Installation And Configuration Manual

Removing and Installing the PA-A2 ATM CES
Port Adatper
This chapter describes how to remove PA-A2 ATM CES port adapters from supported platforms and
also how to install new or replacement modules. This chapter contains the following sections:
•
•
•
•
•
Each PA-A2 ATM CES port adapter circuit board is mounted to a metal carrier and is sensitive to
electrostatic discharge (ESD) damage. Before you begin installation, read
Install the <XXXXX Module>,"
Note When a slot is not in use, a blank must fill the empty slot to allow the router or switch to conform to
electromagnetic interference (EMI) emissions requirements and to allow proper airflow across the
installed modules. If you plan to install a new module in a slot that is not in use, you must first remove
the blank.
When powering off the router, wait a minimum of 30 seconds before powering it on again.
Caution

Handling Port Adapters

Warning Always handle the port adapter by the carrier edges and handle; never touch the port adapter
components or connector pins. (See
OL-346-01
Handling Port Adapters, page 3-1
Online Insertion and Removal, page 3-2
Warnings and Cautions, page 3-3
Port Adapter Slot Divider, page 3-3
Port Adapter Removal and Installation, page 3-6
for a list of parts and tools required for installation.
Figure 3-1.)
PA-A2 ATM CES Port Adapter Installation and Configuration
C H A P T E R
Chapter 2, "Preparing to
3
3-1