Locate the screw at the rear of the port adapter (or blank port adapter) to be replaced. (See
Step 5
Figure 7.) This screw secures the port adapter (or blank port adapter) to its slot.
Figure 7
Location of Port Adapter Screw (Partial Port Adapter View)
Remove the screw that secures the port adapter (or blank port adapter).
Step 6
With the screw removed, grasp the handle on the front of the port adapter (or blank port
Step 7
adapter) and carefully pull it out of its slot, away from the edge connector at the rear of
the slot. (See Figure 8.)
Figure 8
Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)
If you removed a port adapter, place it in an antistatic container for safe storage or
Step 8
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.
Screw
PA-100VG AnyLAN Port Adapter Installation and Configuration
Installing or Replacing a Port Adapter on a VIP2
13