Table of Contents
Advertisement
Chapter 4
Configuring the PA-2FEISL
Enter configuration mode and specify that the console terminal is the source of the configuration
Step 1
subcommands, as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Specify the first interface to configure by entering the interface fastethernet subcommand, followed by
Step 2
the interface address of the interface you plan to configure.
Table 4-1
Examples of the interface fastethernet Subcommand
Platform
Cisco 7100 series; Cisco 7200 series or
Cisco uBR7200 series routers
VIP2
Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using
Step 3
the ip address subcommand, as in the following example:
Router(config-if)# ip address 10.0.0.0 10.255.255.255
Step 4
Add any additional configuration subcommands required to enable routing protocols and set the
interface characteristics.
Reenable the interfaces using the no shutdown command. (See the
Step 5
section on page
Configure all additional port adapter interfaces as required.
Step 6
Step 7
After including all of the configuration subcommands to complete your configuration, press
Ctrl-Z—hold down the Control key while you press Z—or enter end or exit to exit configuration mode
and return to the EXEC command interpreter prompt.
Write the new configuration to NVRAM as follows:
Step 8
Router# copy running-config startup-config
[OK]
Router#
This completes the procedure for creating a basic configuration.
OL-3475-02
Command
interface, followed by type
(fastethernet) and slot/interface
(port adapter slot number/interface
port number
interface, followed by type
(fastethernet) and
slot/port-adapter/port (interface
processor slot number/port adapter
slot number and interface port
number.
4-2.)
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
Configuring the Interfaces
Table 4-1
gives examples.
Example
The example is for the first interface of the
port adapter in slot 4
Router (config)# interface fastethernet
4/0
The example is for the first interface of the
first port adapter on a VIP2 in interface
processor slot 1.
Router (config)# interface fastethernet
1/0/0
"Performing a Basic Configuration"
4-3
Advertisement
Table of Contents
