Using The Show Interfaces Command - Cisco PA-2FEISL-TX Installation And Configuration Manual

100base-t fast ethernet/isl port adapter
Table of Contents

Advertisement

Checking the Configuration
For complete command descriptions and examples for the Cisco 7100 series, Cisco 7200 series, and
Note
Cisco uBR7200 series routers, refer to the publications listed in the
on page
VIP2 in Cisco 7000 Series and Cisco 7500 Series Routers
Use the show diag slot command to determine which type of port adapter is installed on a VIP2 in your
system. Specific port adapter information is displayed, as shown in the following example of a
PA-2FEISL-FX in interface processor slot 3:
Router# show diag 3
Slot 3:
For complete command descriptions and examples for the VIP2, refer to the publications listed in the
Note
"Obtaining Documentation" section on page

Using the show interfaces Command

The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. All of the examples that follow specify serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7100 series, Cisco 7200, Cisco uBR7200 series, and VIP2 interfaces, refer to the publications
listed in the
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
4-10
vii.
Physical slot 3, ~physical slot 0xC, logical slot 3, CBus 0
Microcode Status 0xC
Master Enable, LED, WCS Loaded
Board is analyzed
Pending I/O Status: Console I/O
EEPROM format version 1
VIP2 controller, HW rev 2.04, board revision D0
Serial number: 08224085
Test history: 0x00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 15 02 04 00 7D 7D 55 49 06 94 03 00 00 00 00
0x30: 68 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Slot database information:
Flags: 0x4
Insertion time: 0x1068 (4d22h ago)
Controller Memory Size: 8 MBytes DRAM, 1024 KBytes SRAM
PA Bay 0 Information:
Fast-Ethernet PA, 2 ports, 100BaseFX-ISL
EEPROM format version 1
HW rev 1.00, Board revision A0
Serial number: 00000005
PA Bay 1 Information:
Fast-Ethernet PA, 2 ports, 100BaseTX-ISL
EEPROM format version 1
HW rev 1.00, Board revision A0
Serial number: 00000027
"Obtaining Documentation" section on page
Part number: 73-1684-03
RMA number: 00-00-00
Part number: 73-2619-01
Part number: 73-2618-01
vii.
vii.
Chapter 4
Configuring the PA-2FEISL
"Obtaining Documentation" section
OL-3475-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-2feisl-fx

Table of Contents