Canon imageRUNNER iR2270 Service Manual page 176

No. 002: error rate for all lines; change it so that it is closer to 99%.
No. 003: number of lines in connection with bursts; change it so that it is closer to 99 lines.
No. 004: number of errors falling short of a specific number of lines in connection with
bursts; change it so that it is closer to 99.
- Increase the length of silence after reception of CFR.
Set '1' for service data #1 SSSW SW04 bit 4.
Bit4 -> 1:
-> 0:
length of time during which a low-speed signal is ignored after transmission
of CFR; 1500 msec
length of time during which a low-speed signal is ignored after transmission
of CFR; 700 msec
T-5-3
Chapter 5
5-3