Overview; Guide To Error Code - Canon imageRUNNER iR2270 Service Manual

5.1 Overview

5.1.1 Guide to Error Code

When the Board has been installed and '1' is set for service data #1 SSSW SW01 bit 0,
communications ending in error will be indicated in the following reports using service
error codes: communications management report, reception result report, and error
transmission report.
You can also check the code of an error by making the following selections: System
Monitor > Fax > Detail.
The major error codes used by the Board are listed on the pages that follow. For information
on causes and remedies in connection with other error codes, see the "G3/G4 Facsimile
Error Code List" (HY8-23A0-020).
If the Board indicates a service error code, try the following:
- Increase the transmission level.
Set -8 (dBm) for service data #2 MENU parameter No. 007.
- Decrease the transmission level.
Set -15 (dBm) to service data #2 MENU parameter No. 007.
- Provide a remedy against echoes.
Change the following bit setting for service data #1 SSSW SW03:
F-5-1
Chapter 5
0007-6273
5-1