Canon imageRUNNER iR2270 Service Manual page 29

Menu Num Ncu Type
Sssw
SW01
SW02
SW03
SW04
SW05
SW06
SW07
SW08
Previous Page/Next Page key
F-4-2
- If you want to change 0 to 1 or 1 to 0 on a bit switch, press the desired bit (number) directly.
- If you want to store a change or execute an item, press the OK key.
- Use the keypad to enter a numerical value.
- To return to the previous level of selection, press the Reset key.
If you changed a setting in service mode, be sure to turn off and then on the power
(making sure that you first turn off the control panel switch and then the main power
switch). The settings made in service mode are stored on the hard disk. The settings
associated with the Board are loaded to the G3 fax control PCB only when the main
power is tuned on, thus requiring you to turn it off and then on after making a change.
ISDN
0 0 0 0
1 0 0 0
0 0 0 0
1 0 0 0
0 0 0 0
1 0 0 0
0 0 0 0
1 0 0 0
Print Clear Test
<1/7>
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
OK
Press to accept the current input.
Report
<READY>
Chapter 4
4-3