Removing The Mini-Ygdai Card; Installing An Hy Card - Yamaha RIVAGE PM7 Systems Setup Manual

3.
Align both edges of the card with the guide
rails inside the slot, and then insert the card
into the slot.
Push the card all the way into the slot so that the
connector at the end of the card is correctly inserted
into the connector inside the slot.
4.
Fasten the card using the screws attached to
the card.
If the card is not fastened securely, component failure
or malfunction may occur.
Removing the Mini-YGDAI
card
1.
Make sure that the power is turned off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Completely loosen the screws that hold the
card in place.
3.
Pull the card toward you while holding the
screws on the card.
4.
Replace the stored slot cover and affix it with
the screws.
Card

Installing an HY card

1.
Make sure that the POWER indicator is turned
off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that fasten the slot cover
to remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
3.
Align both edges of the HY card with the
guide rails inside the slot, and then insert the
card into the slot with the card installation
lever pressed down.
NOTE
For information on which cards support each slot, refer to
"Introducing the devices" on page 10.
RIVAGE PM7 System Setup Guide
Slot cover
Card
31