Removing An Hy Card - Yamaha RIVAGE PM7 Systems Setup Manual

Push the card all the way into the slot so that the
connector at the end of the card is correctly inserted
into the connector inside the slot.
4.
Pull up the card installation lever to lock in the
card.
Make sure that the lever claw is securely locked under
the bottom part of the slot.
NOTE
If the lever claw does not lock in, pull up the card slightly,
then push it in.
5.
Affix the card using the screws that were
previously used to affix the slot cover.
If the card is not fastened securely, component failure
or malfunction may occur.
32 RIVAGE PM7 System Setup Guide

Removing an HY Card

1.
Make sure that the power indicator is turned
off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that hold the card in
place.
3.
Unlock the card by pressing the red button on
the card installation lever.
4.
Press down the card installation lever to pull
out the card.
5.
Replace the stored slot cover and affix it using
the screws.