Yamaha RIVAGE PM7 Systems Setup Manual page 25

1
3
5
6
7
8
9
)
!
#
1 PIN indicator
Lights when the Pinning function for the [TOUCH
AND TURN] knob is ON.
2
(This feature will be supported by a future update.)
2 [TOUCH AND TURN] knob
Controls the parameter of the knob you are touching
4
on the touch screen.
3 Channel strip encoder display
Indicates the function that has been assigned to the
channel strip encoder.
4 UP [U]/DOWN [D] keys
Enable you to select the function that you want to
control using the channel strip encoder.
5 [SHIFT] key
Combine with another key to perform a certain
function.
The following table shows examples of using the
[SHIFT] key combined with another key. For more
information, please refer to the Operation Manual.
Procedure
Press and hold down the
[SHIFT] key and press the
[CUE] key, and then
release the [SHIFT] key.
6 [SENDS ON FADER] key
Turns SENDS ON FADER mode on and off.
7 INPUT [1-72]/[73-120] keys
Enable you to select an input layer.
8 OUTPUT [MIX]/[MATRIX] keys
@
Enable you to select an output layer.
9 [DCA] key
Enables you to select a DCA layer.
) CUSTOM [1]/[2] keys
Enable you to select a custom layer. You can assign
custom faders of two banks (total of 12 layers) to each
custom layer.
! Layer display
Indicates the selected layer.
Function
To switch cues as the
channel's send destination.
(A ➝ B ➝ A&B ➝ A)
RIVAGE PM7 System Setup Guide 25