Application "1-Button Operating Mode "Setting "Adjust Room Temperature Controller; General Parameters - Object Type For Output - ABB i-bus KNX 6108/06-500 Technical Reference Manual

Application "1-button operating mode "Setting "Adjust room temperature controller""

10.12 Application "1-button operating mode "Setting "Adjust room temperature controller""
NOTE
The application is valid for the following parts of the device:
■
■
■
■
With the "1-button operating mode" "Adjust room temperature controller"" application, an
operating mode switchover for connected room temperature controllers can be carried out with
an operation of one button side.
Depending on the setting of the "Object type for output" parameter, the application offers either
1-bit communication objects "Comfort operating mode", "Standby operating mode", "ECO
operating mode" and Frost protection, heat protection operating mode" or 1-byte communication
objects "Auto operating mode", "Comfort operating mode", "Standby operating mode", "ECO
operating mode" and "Frost protection, heat protection operating mode".
The selection "1-bit" is used for activating room temperature controllers that have 1-bit
communication objects for operating mode switchover. The "1-byte" selection is used for
activating room temperature controllers that have a 1-byte communication object for operating
mode switchover to KNX. In this case, the values mean:
– 0 = Auto
– 1 = Comfort
– 2 = Standby
– 3 = Eco
– 4 = Frost- / heat protection
The function can be temporarily blocked via a 1-bit "Enable" communication object.

10.12.1 General parameters - Object type for output

Options:
The "Object type for output" parameter is used to specify the size of the output communication
object. You can select between "1-bit" and "1-byte".
The selection "1-bit" is used for activating room temperature controllers that have 1-bit
communication objects for operating mode switchover. The "1-byte" selection is used for
activating room temperature controllers that have a 1-byte communication object for operating
mode switchover to KNX. In this case, the values mean:
– 0 = Auto
– 1 = Comfort
– 2 = Standby
– 3 = Night
– 4 = Frost- / heat protection
KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905
Description of application and parameters
Button 1 / rocker 1
Button 2
Button 3 / rocker 2
Button 4
1 bit
1 byte
│56