Table of Contents
Advertisement
10.20
Application "Enable application"
NOTE
This application can be activated via "Enable device".
If the "Enable application" parameter is set to "activated", the function can temporarily be
blocked via the the 1-bit communication object "Enable".
The function is active if an ON telegram is received on the 1-bit communication object "Enable".
The function is blocked if an OFF telegram is received on the 1-bit communication object
"Enable". This means that no telegram is sent out on the operating mode communication
objects.
10.20.1 General parameters - Enable with
Options:
The function is active if an ON telegram is received on the 1-bit communication object "Enable".
The function is blocked if an OFF telegram is received on the 1-bit communication object
"Enable". This means that no telegram is sent out on the operating mode communication
objects.
10.20.2 General parameters - After bus voltage recovery the device is
Options:
The parameter "After bus voltage recover the device is" exists to permit a defined behaviour at
the "Enable" communication object after a return of bus voltage. Here it is specified whether a
"1" ("enabled") or a "0" ("blocked") is present on the enable object after the return of bus
voltage.
10.20.3 General parameters — Use of automatic enable/blockage
Options:
Automatic enable or automatic blockage can be activated via parameter "Use of automatic
enable/blockage". It can also be used to deactivate an automatic function.
KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905
Description of application and parameters
On telegram
Off telegram
Blocked
Enabled
No
Automatic enable
Automatic blockage
Application "Enable application"
│81
Advertisement
Table of Contents
