Omron CJ2 Series Network Connection Manual page 10

5. Applicable Devices and Device Configuration
Precautions for Correct Use
Prepare the latest "Sysmac Studio project file" and "Network Configurator v3 network
configuration file" from OMRON in advance.
(To obtain the files, contact your OMRON representative.)
Precautions for Correct Use
Update the Sysmac Studio and CX-Programmer to the versions specified in this section or
higher versions using the auto update function.
If a version not specified in this section is used, the procedures described in Section 7 and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in the Sysmac Studio Version 1 Operation Manual (Cat. No. W504), Network
Configurator Online Help and CX-Programmer Operation Manual (Cat. No. W466).
Additional Information
The system configuration in this document uses USB for the connection to the Controller. For
information on how to install a USB driver, refer to A-1 Driver Installation for Direct USB Cable
Connection of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
Additional Information
The system configuration in this document uses USB for the connection between the
personal computer and PLC. For information on how to install the USB driver, refer to A-5
Installing the USB Driver of the CJ-series CJ2 CPU Unit Hardware User's Manual (Cat. No.
W472).
7