Duodrill - horsch Tiger AS Series Operating Instructions Manual

DuoDrill

Installing the control
For all machines with a drill controls the basic
equipment must first be mounted to the tractor
during initial installation.
The cables of the basic equipment include
2 x 10 mm² for the power supply and 2 x 2.5 mm²
for the electronics supply.
The cables must be directly connected to the
tractor battery.
The cables must be protected against chafing
and the insulation must not be damaged.
The battery connections must have reliable
contact. Assembly faults will lead to voltage drop
and indefinable error messages and failures.
The cables must under no circumstances
be connected to any other plugs in the cab.
The monitor should not obstruct the driver's field
of vision to the road
58
Assembly
Basic equipment with monitor
Assemble the monitor bracket in a suitable
¾
place within the view and the operating range
of the driver.
Route the thick cable to the battery, extend
¾
it if necessary.
Connect both fuse holders tightly and durably
¾
with the cable (see illustration).
Connect the two red cables tightly with battery
¾
plus and the two black cables with battery
negative.
Fasten the monitor bracket to the back of the
¾
monitor and plug the connecting cable in at
the bottom of the monitor.