Goliath Tines; Maintenance - horsch Tiger AS Series Operating Instructions Manual

2
1
MulchMix Coulter
1 Narrow or wide coulter tip
2 Narrow or wide guide plate
3 Narrow or wide coulter
Changing the coulter
The following must be observed when replac-
ing components of the MulchMix, LD and ULD
coulter (coulter tips, guide plates, wings):
Use only original HORSCH wear items.
¾
Use new screws and nuts with each replace-
¾
ment.
Check for correct seating of the four-cornered
¾
shaft coulter screws in the coulter tips and
guide plates:
Observe the sequence when tightening
¾
MulchMix coulter tips together with guide
plates:
1.
3.
2.
40
Tighten the screw connections for mounting
¾
the wings on the nut. Do not tighten on the
screw head.
3
Tighten all screw connections with a nutrunner
¾
or torque spanner.
Observe the tightening torque: 160 ± 10 Nm
¾

Goliath tines

The "Goliath" tine is installed in the Tiger XL. The
tines are equipped with 5.5 cm wide coulters.
"Goliath" Tines

Maintenance

The tines are maintenance free.
The bolts on the tool carrier must be checked
for tightness after the initial operating hours and
before the start of the season.