System Set-Up Menu - Respironics SmartMonitor2 Operator's Manual

After the new parameters have been entered into the SmartMonitor 2, the monitor must be turned off to
exit Menu Mode.
To set the parameters through the Synergy-E computer software, refer to the Synergy-E Manual for
instructions on communicating with the SmartMonitor 2.

System Set-up Menu

SmartMonitor 2 also has a System Set-up Menu, which displays the entire menu of parameters. This
includes very seldom-used menu choices. In addition to some menus previously seen, you will have
access to the following menus. To access this menu, do the following:
Press the POWER button ON. After a short delay, the display will read:
INITIALIZING PLEASE WAIT
Then,
MENU MODE? ENTER PROPER KEY SEQUENCE
Press the keys in the following sequence within 10 seconds:
Press the t Up arrow 3 times.
Press the ENTER button 3 times.
Scroll to MENU OPTIONS and press ENTER.
Scroll to SYSTEM MENU and press ENTER.
The following table lists the additional options available from the System menu:
Menu Option
Date Format
Memory Full Alert
Memory Full Audible
Modem Speed -
Monitor
LCD Display
DATE FORMAT
MEMORY FULL ALERT
MEMORY FULL AUDIBLE
Modem Speed-Monitor
Setting Alarm and Recording Limits
Description of Option or Instructions
Permits the selection of two formats for
displaying the DATE:
MONTH/DAY/YEAR or
DAY/MONTH/YEAR
Standard value: Month/Day/Year
Two options are available: 80% full or
50% full.
When the memory usage reaches the
selected limit (50% or 80%), the unit will
generate an alarm.
Standard value: 50%
Used to enable/disable the audible alarm
when the unit reaches the selected
memory almost full limit (50%/80%).
NOTE: This parameter does not affect the
visual indicator; it cannot be disabled.
Values:
ON, OFF
Standard Value: OFF
The default setting is 38,400Bps. This
setting should not be change unless
directed to do so by Respironics
Technical Support.
27