Advertisement

U S E R M A N U A L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HomeLOX and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Respironics HomeLOX

  • Page 1 U S E R M A N U A L...
  • Page 2: Table Of Contents

    Symbol Key ....................... 2 Introduction ..................3 Intended Use ....................3 Warnings and Cautions ................3 Compatibility with Portable Oxygen Devices ........4 How to Contact Respironics................ 4 How the System Works ..............5 Troubleshooting Guide ...............10 Cleaning ..................11 Circuit Breaker Instructions ............12 Specifications ................13...
  • Page 3: Symbol Key

    GoLox-93 - the small and wearable device that stores liquid oxygen and controls the flow of oxygen to the user. • LED - Light Emitting Diode • Liquefaction Unit - the HomeLox, which produces liquid oxygen and is used to fill the GoLox-93. • LOX - Liquid Oxygen •...
  • Page 4: Introduction

    • Do not set any objects on, or allow to be draped over, the HomeLox System as they might block air flow into the device. Place the unit in a ventilated location with the sides and rear two feet away from any object.
  • Page 5: Compatibility With Portable Oxygen Devices

    • The HomeLox System contains liquid oxygen and is therefore designed to operate on a level surface and in an upright position. Should the unit be upset or overturned, liquid oxygen could spill. Should this occur, discontinue its use and immediately contact your home care equipment supplier.
  • Page 6: How The System Works

    Respironics GoLox-93 portable liquid oxygen device for your use as a source of ambulatory oxygen. The HomeLox is only a liquid oxygen reservoir for filling a portable unit and will not provide any ability for you to breathe oxygen gas directly from it. This device is not intended to be life supporting nor life sustaining.
  • Page 7: Getting Started

    Getting Started Begin by becoming familiar with your HomeLox and the Control Panel. Description Function Control Panel HomeLox control switches and indicators Turntable Used to rotate the GoLox-93 to fill it with liquid oxygen Connects the GoLox-93 and valve for transfer of liquid oxygen from the...
  • Page 8 Off – No system faults have been detected. will not start again until the problem is corrected. PAUSE When this switch is Steady On – The HomeLox is paused; it is in a temporary non- Push Button & depressed, the unit stops operating state. Indicator...
  • Page 9 Warning: Do not leave the GoLox-93 unattended while it is filling. Warning: Risk of electrical shock if unit is accidentally immersed or if fluids are spilled on the HomeLox device. Do not allow fluids to come in contact with the device, as they may create a shock hazard.
  • Page 10 10. Move the Vent Fill Lever on the back of the GoLox-93 to its closed, upright position. 11. Rotate the turntable on the top of the HomeLox counter-clockwise until it stops. Notice that the indicator lines on the turntable align with the lines on the HomeLox.
  • Page 11: Troubleshooting Guide

    Respironics, Inc. or a trained representative. If your HomeLox fails to operate properly, refer to the chart below for possible solutions. If your problem is not listed here, contact your home care equipment supplier. Do not attempt any maintenance procedures other than those listed below.
  • Page 12: Cleaning

    Warning: Do not use any oil, grease, or petroleum-based products on or near this unit. The outer housing of the HomeLox may be cleaned with a mild household detergent and a damp cloth or sponge. Avoid using large quantities of water to clean the unit, and do not use any petroleum-based solvents or cleaning agents.
  • Page 13: Circuit Breaker Instructions

    Circuit Breaker Instructions During normal operation, mains power is connected to the HomeLox and the circuit breaker button is depressed. If mains power is disconnected, the circuit breaker is activated and the button is not depressed. To reset the circuit breaker: •...
  • Page 14: Specifications

    HomeLox User Manual Specifications Environmental Operating Transport & Storage Temperature 55° F (12° C) to 90° F (32° C) -4° F (-20° C) to 140° F (60° C) Relative Humidity 15 to 95% (non-condensing) 15 to 95% (non-condensing) Physical Dimensions: 18.8 in x 19.4 in.
  • Page 15: Emc Information

    EMC Information ’ UIdanCe and anUfaCTUrer eClaraTIon leCTromagneTIC mIssIons This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment. mIssIons omplIanCe leCTromagneTIC nvIronmenT UIdanCe RF emissions Group 1...
  • Page 16 HomeLox User Manual ’ UIdanCe and anUfaCTUrer eClaraTIon leCTromagneTIC mmUnITy This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment. IeC 60601 T...
  • Page 17: Limited Warranty

    Product contains a defect in materials or workmanship and such Product is returned to Respironics within the warranty period, Respironics will repair or replace the Product, or issue a credit for the purchase price of the Product, with the choice to repair, replace or credit being within the sole discretion of Respironics.
  • Page 18 ref 1050628 1059881 R01 JH 3/23/11...

Table of Contents