Modem Auto Dial; Modem Auto Answer In Communications Mode - Respironics SmartMonitor2 Operator's Manual

Modem Auto Dial

The SmartMonitor 2 must be connected to AC power during modem download.
To have SmartMonitor 2 call the computer for a download it must be programmed with a Host Phone
Number, which is the phone number to be called for a connection with the computer as well as the date
and time to call. If the phone number field is blank, no attempt to call will be made. These must be set up
in the SmartMonitor 2 before it is placed in the patient home. When the preset time for download
approaches or when the memory full light illuminates, follow these instructions:
If there is an emergency and access to the telephone is required while the modem is in use,
remove phone cord from modem slot and use a working phone.
Plug the telephone wire into the modem connector on the
back of the SmartMonitor 2 (see illustration).
Plug the other end of the phone wire into the wall phone jack.
Refer to the Synergy-E software for instruction on receiving
a call from the SmartMonitor 2.
Modem will continue calling every 30 minutes, for 4 hours
until it connects with the computer. If no connection is made,
the modem will try again the next day at the pre-selected
time. For example, if the modem is programmed to call at
7am but fails to make a connection after 8 attempts it will
stop trying. The next day at 7am it will try again. This will
continue until a connection is made.

Modem Auto Answer in Communications Mode

The SmartMonitor 2 must be connected to AC power during modem download.
1. Connect a phone cord from the wall jack to the modem connector on the back of the SmartMonitor 2.
2. To allow the SmartMonitor 2 to work with the modem, place the monitor in Communications Mode:
Press and release the POWER button to turn the SmartMonitor 2 on.
Press and hold the blue RESET button.
Wait until the monitor alarms.
Release the RESET button. Briefly press and release the RESET button again. The SmartMonitor
2 display will read "Monitor is in Communication Mode".
The SmartMonitor 2 beeps every 10 seconds whenever it is in the Communications Mode. This is a
reminder that the SmartMonitor 2 is powered on for working with the computer, memory card, or modem,
but not for monitoring the infant.
Do not connect the infant to the SmartMonitor 2 when in the Communications Mode, the apnea
and heart rate alarms are not operational in this mode.
The dealer should now call to retrieve the information. The phone may ring, but do not answer.
The modem answers the call and connects the SmartMonitor 2 to the computer through the
phone line.
4. The amount of time to transfer the information will vary.
Transferring SmartMonitor 2 Information
When the transfer is complete the
54