Operating The Device; Connect The Power Supply - Hirschmann BAT450-F User Manual

The supply voltage is electrically isolated from the housing.
Type and specification of the
supply voltage
Nominal voltage DC
24 V
Voltage range DC incl. maximum
tolerances
16.8 V ... 32 V
Table 3: Type and specification of the supply voltage
For every supply voltage to be connected, perform the following steps:
 Connect the wires for the supply voltage according to the pin assignment
with a suitable socket.
2.5

Operating the device

Perform the following steps to start up the device:


Connect the power supply

 Defining IP parameters
 Defining WLAN basic settings

Configuring the transmit power
2.5.1 Connect the power supply
You start up the device by connecting the power supply via the 8-pin, X-
coded M12 socket for PoE port or via a 5-pin, A-coded M12 socket.
 Only connect the device to a PoE network indoors.
 Only run data links indoors (IEEE 802.3 area A).
8-pin, X-coded M12 plug for PoE port

 Connect the data cables according to your requirements.
5-pin M12 plug, A-encoded

 Connect the data cables according to your requirements.
 Plug the socket into the M12 plug on the device.
 Enable the supply voltage.
26
Pin assignment on the device
3
2
5
1
4
2
3
4
5
1 +24 V DC
0V
0V
N.C.
N.C.
Installation BAT450-F
Release 03 08/2016