Table of Contents
Advertisement
The use of antennas missing in this list is strictly prohibited. The required
antenna impedance is 50 ohms.
Note (1): When using 3 antennas type BAT-ANT-RSMA-2AGN-R, you
must align each antenna in another spatial direction (x-y-z) so that one
antenna is arranged vertically to the device and the other two antennas
are arranged at right angles to each other.
Note (2): Connect the BAT-ANT-N-MiMo-18N-IP65 antenna to the WLAN
module as follows:
Connect the antenna port "Ver" with the WLAN antenna port 1.
Connect the antenna port "+45°" with the WLAN antenna port 2.
Connect the antenna port "+45°" with the WLAN antenna port 3.
Connect the BAT-ANT-N-MiMo-18N-IP65 in this way exclusively.
Differing connection configurations are illegal.
Recycling note
After usage, this device must be disposed of properly as electronic waste,
in accordance with the current disposal regulations of your county, state,
and country.
12
Installation BAT450-F
Release 03 08/2016
Advertisement
Table of Contents
