Configuring The Ap For Standalone Operation - Ruckus Wireless T504 Installation Manual

Configuring the AP for Standalone Operation

NOTE If the T504 is going to be managed by an AP controller or manager, then
skip this section and continue with
Logging Into the AP's Web Interface
1 Collect required equipment and information:
• The IP address assigned to the AP by the CMTS DHCP server.
• An administrative computer as configured as described in
Administrative
• One Cat5e or better Ethernet cable.
• AP MAC address (12 alphanumeric digits) from the outside of the AP case.
2 Verify that the AP is powered on as described in
3 Use a 7/16" (11mm) wrench to remove the reset button and diagnostic Ethernet
port screw-in plug (see
4 Connect one end of the Ethernet cable to the administrative computer's Ethernet
port, and then connect the other end to the T504's Ethernet port.
5 In an administrative computer address or location bar, type the following address:
https://192.168.100.2
--OR--
the IP address assigned to the AP by the CMTS DHCP server
6 Press <Enter>. A security alert message appears.
7 Click Yes or OK or Proceed anyway (depending on the browser) to continue.
The AP's login page appears.
Figure 14. The Ruckus Wireless Access Point login page
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
Verifying CM and AP
Computer.
Figure 5).
Installing the T504
Deploying the T504
Operation.
Preparing the
Powering the T504 with POC.
34