Copper Or Fiber Optic Module Replacement; Removing A Copper Or Fiber Optic Module - Extreme Networks ExtremeSwitching CES 2000 Series Hardware Installation Manual

Copper or Fiber optic module replacement

2. Unscrew the two screws that secure the fan tray to the chassis.
FIGURE 57 Replacing the fan tray
3. Slide the fan tray out
4. Slide the new fan tray in and tighten the screws to secure it to the chassis.
5. Plug the chassis back in and power up.
Copper or Fiber optic module replacement
You can remove an SFP, SFP+, or XFP from a port and replace it with a new one while the Extreme Networks device is powered on and
running.
This section provides information about the following tasks:
•

Removing a copper or fiber optic module

• Installing a new copper or fiber optic module
• Cabling a fiber optic module
Removing a Copper or fiber optic module
You can remove a copper or fiber SFP (also called a mini-GBIC), SFP+, or an XFP from a port while the Extreme Networks device is
powered on and running.
Before removing a copper or fiber optic module, have the following on hand:
• An ESD wrist strap with a plug for connection to the ESD connector on the Stackable device.
88
ExtremeSwitching CES 2000 Series and ExtremeRouting CER 2000 Series Hardware Installation Guide
9035631-01