Extreme Networks ExtremeSwitching CES 2000 Series Hardware Installation Manual page 60

PC or terminal attachment
2. Open the terminal emulation program and set the session parameters as follows:
• Baud: 9600 bps
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
When you establish the serial connection to the system, press Enter to display the CLI prompt in the terminal emulation window.
For example:
device>
If you see this of these prompt, you are now connected to the system and can proceed to
You can customize the prompt by changing the system name. For more information, refer to the Extreme NetIron Management
Configuration Guide.
If you do not see one of these prompts, follow the instructions given below.
3. Make sure the cable is securely connected to your PC and to the system.
4. Check the settings in your terminal emulation program. In addition to the session settings listed above, make sure the terminal
emulation session is running on the same serial port you attached to the system.
The EIA/TIA 232 serial communication port serves as a connection point for management by a PC or SNMP workstation.
60
ExtremeSwitching CES 2000 Series and ExtremeRouting CER 2000 Series Hardware Installation Guide
Attaching a PC or terminal.
9035631-01