How To Record And Play A Waveform - Owon VDS Series User Manual

Save rule
Save: Save current rule.
Use: Load the selected rule in the list as the testing rule.
Remove: Remove the selected rule in the list.

13.How to Record and Play a Waveform

Wave Record function can record the input current wave. You can set the interval between recorded frames and get better analysis effect with
playback and storage function. The limit of the saved file size is 4000M. It will save the initial trig status, the time base, voltage division,
horizontal trigger position and zero position of each frame during recording.
Click to show Function menu, choose "Record".
Record
1. Choose "Record" tab on the top.
2. Click "Preset Save Path" to specify the save location. Waveform files have the suffix ".cap".
3. Set "Interval Time" and "End Frame". Interval Time refers to the interval between recorded frames. Interval Time ranges from 0 to 100000ms
and increment by 10ms.
4. Make the waveform in Run status.
5. Click "Begin Record". Counter starts to count the frame number.
6. Click "End Record" to stop recording, or wait until the Counter reaches the End Frame.
Note:
1.Waveforms of two channels can be recorded simultaneously.
2.You can turn on/off the channels while recording. Only channels turned on can be recorded. If a channel is turned off while recording, there will
be no waveform of this channel after the frame when stopped.
Replay the waveform recorded
26