Test Case 10 - Simulate Primary Cp Failure To Test Ha; Test Case 11 - Reinsert The Failed Primary Cp - Avaya VSP 9000 Technical Configuration Manual

5.10 Test Case 10 – Simulate primary CP failure to
test HA
The objective of this test case is to test HA by confirming that removing the master CP causes no data
loss.
Test Steps
1) Run Vdbench from all the PCs.
Confirm that Vdbench is running
correctly.
2) Ensure that HA is enabled on the
show boot config
VSP with
flags
.
3) Remove the master CP on the
VSP 9000, the standby CP should
come up as the master.
4) Wait for Vdbench to finish reading
and writing to verify the results.
5.11 Test Case 11 – Reinsert the failed primary CP
The objective of this test case is to reinsert the failed primary CP from Test Case 10 to validate that the
CP comes up as the standby CP.
Test Steps
Run Vdbench from all the PCs.
Confirm that Vdbench is running
correctly
Ensure that HA is enabled on the
VSP with show boot config flags.
Insert the CP that was removed in TC
10.
This CP should come up as the
standby.
Wait for Vdbench to finish reading
and writing to verify the results.
Dec 2010
Expected Results
Vdbench should be reading and
writing on all PCs.
HA mode should be enabled on the
VSP.
Standby CP should come up as
master.
Confirm that Vdbench doesn't notice
the failure and continues reading and
writing data to the storage array.
Vdbench should finish with no errors
in the log file and all data should be
validated.
Expected Results
Vdbench should be reading and writing
on all PCs.
HA mode should be enabled on the
VSP.
The newly inserted CP should come
up as a standby CP and the master
CP should be unaffected. From the
console, confirm that no error
messages appear.
Vdbench should finish with no errors in
the log file and all data should be
validated.
VSP 9000 with Coraid EtherDrive SRX-Series
Storage Appliances TCG
avaya.com
Actual Results
Pass
Pass
Pass
Pass
Actual Results
Pass
Pass
Pass
Pass
27