Chapter 5 - Maintenance - Alcatel Drytel 100 Instruction Manual

CHAPTER 5 - MAINTENANCE

.1 · GENERAIJTIES
,
- For any operation of maintenance, stop the DRYTEL and disconnect the line cable.
- Remove the DRYTEL from the pumping installation
- Unscrew the 4 assembling screws located on the DRYTEL side panels and remove the body.
- Disconnect the electrical cable from the frame, on the connector Jo.
5.2. · MOP 5030 CP · MAINTENANCE
The bearings of the MDP have been properly lubricated prior to assembly and testing. It is essential that you
familiarize yourself with the relubrication intervals detailed in figure 5/1 and 5/2 of this manual.
5.2.1 DISASSEMBLY OF THE MDP
- Disconnect the cable between MDP and converter.
- Remove the quick connect clamp from the discharge vacuum line.
- If the MDP is water cooled, remove the two clamping collar from the water line.
�
..
Remove the 4 screws assembling MDP and its support on the shocks absorber .
:,
5.2.2. RELUBRICATION
The MDP must be properly maintened to insure optimum performance and minimum downtime. You must
use only the grease contained in the syringe available from Alcatel.
When adding grease, proceed carefully with maximum cleanliness.
WARNING!
. The MDP has 2 ball bearings: at every relubrication (see fig. 5/1 and 5/2) schedule, the user must
the
relubricate two ball bearings .
. The syringe is equipped with 2 removable black spacers :
- one spacer for the ball bearing near the pumping unit.
• the other spacer for the ball-bearing opposite the pumping unit.
41