Conventions - In-situ Level Troll 300 Operator's Manual

seCtion 1: introduCtion
Level trOll Operator's Manual
Section 2: Components and features of the Level TROLL system
— Accessories — Product Specifications
Section 3: Getting Started — Select a TROLL Com — Install the Software
— Connect the Hardware
Section 4: Using Win-Situ — Connecting for the First Time — Setting the
Clock — Setting a Device Site — Preparing to Log Data —Disconnecting
Section 5: About the Pressure (Level) Sensor: The two basic types of
pressure sensors — Factory and field calibration
Section 6: Field Installation — Guidelines and Precautions for Long-Term
Deployment of the Level TROLL
Section 7: The BaroTROLL
Section 8: Connecting for use with SDI-12, Analog (4-20 mA), and Modbus
loggers and controllers
Section 9: Care & Maintenance
Section 10: Troubleshooting

Conventions

Throughout this operator's manual you will see the following symbols.
The check mark highlights a tip about a convenient feature of the Level
TROLL
The exclamation point calls your attention to a requirement or important
action that should not be overlooked
7
0052210 rev. 006