In-situ Aqua TROLL 800 Quick Start Manual
Hide thumbs Also See for Aqua TROLL 800:

Advertisement

Quick Links

1
3
4
5
6

Install the batteries.

1
Unscrew the battery
cover to remove it.
Your Aqua TROLL 800 ships with all sensors installed except for pH/ORP or ISE sensors. If your
instrument does not include pH/ORP or ISE sensors, all six sensors are installed by the factory.
All sensors are factory calibrated and do not need to be recalibrated unless required by site procedures.
2

Install the RDO Cap (RDO sensor only).

Remove the restrictor.
Information subject to change without notice. In-Situ, In-Situ logo, "Water Simplified", VuLink, RDO, RuggedCable, TROLL,
BaroTROLL, HydroVu, VuSitu, Baro Merge, and Win-Situ are trademarks or registered trademarks of In-Situ Inc. ©2023. All
rights reserved. This product may be covered by patents identified at www.in-situ.com/patents
2
7
8
9

Getting Started

Bend rubber cover back
and insert the batteries.
Use included hex wrench
to loosen set screw on
RDO sensor.
Aqua TROLL 800 Quickstart Guide

Box Contents

1. Instructions
2. Instrument with sensors and wiper or wiper plug installed
3. Hex Wrench
4. Screwdriver
5. RDO Sensor Cap (if RDO Sensor is included)
6. Batteries
7. pH/ORP or ISE Sensors (if selected)
8. Accessories
9. pH maintenance kit (if pH/ORP or ISE sensors are included)
Replace the battery
cover.
Use the small hole at the
bottom of the sensor to
lever the sensor out.
Remove the dust cover
from the RDO sensor.
2023-06-05 | 0045802

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Aqua TROLL 800 and is the answer not in the manual?

Questions and answers

Summary of Contents for In-situ Aqua TROLL 800

  • Page 1 Your Aqua TROLL 800 ships with all sensors installed except for pH/ORP or ISE sensors. If your instrument does not include pH/ORP or ISE sensors, all six sensors are installed by the factory. All sensors are factory calibrated and do not need to be recalibrated unless required by site procedures.
  • Page 2 Connect the Rugged Cable and communication device. O-ring Remove protective caps Apply a pea-sized drop Align the flat edges Slide connector into the from instrument and of grease to the O-ring. of the instrument cable end. cable. connector and the cable. 1-970-498-1500 www.in-situ.com...
  • Page 3 You must have the VuSitu mobile app to use the instrument with a mobile device. Download VuSitu from the Google Play Store or the Apple App Store. Android Aqua TROLL 800 The app locates and Launch VuSitu and tap displays nearby In-Situ Connect.
  • Page 4 800. If you have questions, contact In-Situ Technical Support for assistance. • Use only D-cell alkaline batteries. • Do not use the Aqua TROLL 800 in any manner not specified by the manufacturer. • Do not use batteries of different ages or types.
  • Page 5 • No utilice el Aqua TROLL 700 de ninguna forma no especificada por el fabricante. • Ne jamais utiliser l'Aqua TROLL 800 autrement que de la manière spécifiée par le fabricant. • No utilice baterías de diferente antigüedad o tipo.

This manual is also suitable for:

0045800

Table of Contents