Introduction to the 750w
General
The 750w² Monitor is designed to work with Partech's WaterWatch² (w²) sensors. It combines a
clear display of the measured parameter and a simple user interface with flexibility to enable
configuration to satisfy the users needs.
Display
The 750w² display indicates the measured value with large numerals with an additional status line
that shows the current settings, battery status, and any faults that are present. The display has a
backlight to enable use of the monitor in low light conditions and also has adjustable contrast.
The measurement title and units can all be user set to suit the sensor being used and the
application being monitored.
Keypad
The 7 key tactile membrane keypad is used for all configuration and operation of the 750w²
Monitor.
Sensors
The 750w² Monitor can currently be used with the SoliTechw² IR sensor range, OxyTechw² RDO
sensor, and the WaterTechw² Temperature sensor.
Manual Conventions
This instruction manual describes the configuration and operation of the 750w² Monitor and where
required includes some information regarding sensors. It is therefore very important that it is used
in conjunction with the relevant sensor quick start guides shipped with each project.
The manual has been written on the basis that the user has a basic knowledge of instrumentation
and an understanding of the type of measurement being made. Training in the use of the 750w²
Monitor can be provided by Partech, please contact Partech for further information
Display Value
Status Bar
Monitor
2
Measurement
Units
Battery status
8