DFI TPC150-SD User Manual page 13

Installing a Mini PCIe Card
The system board is equipped with one Mini PCIe slot that supports mSATA and PCIe interfaces.
Use the following procedure to install a Mini PCIe card:
Align the notch in the connector of the Mini PCIe card with the key in the connector on the
system board and use the provided mounting screws to secure the card on the system board.
Note:
The Mini PCIe socket supports PCIe and SATA signals and can accommodate
common mobile broadband and storage modules. For jumper settings on switching
the signal betwen SATA and PCIe, refer to Chapter 4.
Chapter 3 Installing Devices
Chapter 3
Installing a PCIe Expansion Card
The PCIe slot on the riser card inside the system is used to install expansion cards. Use the
following procedure to install a Mini PCIe card:
Note: The system provides two optioanl riser cards to accommodate different types
of PCIe expansion slots:
The riser card
whereas the riser card
PCIe slots.
1. Remove the slot plate and bracket by removing the screws on the front chassis.
2. Insert the expansion card into the PCIe slot on the riser card. Ensure the card is properly
seated into the slot.
Mini PCIe card
Mounting screw
13
(DFI model: T100-2E) provides 2 x PCIe Gen3 x8 expansion slots
(DFI model: X100-2P1M)
provides two PCI and one Mini
Slot plate
bracket and screws
PCIe slot
www.dfi.com