Installing A Sata Drive - DFI TPC150-SD User Manual

Installing a SATA Drive

The system can accomondate two SATA drives. Please use the following procedure to install
SATA drives into the system.
1. Locate the SATA drive bay inside the system and remove the mounting screws that
secure the HDD bracekt to the drive bay.
2. Align the mounting holes of the SATA HDD with the mounting holes on the HDD drive bay
and use the mounting screws included in the HDD drive bay kit to attach the SATA HDD to
the drive bay.
SATA drive
HDD bracket
Mounting screw
Chapter 3 Installing Devices
Chapter 3
3. Place the SATA drive (with the HDD bracket) back into the system. Align the mounting
holes on the HDD bracket with the mounting holes on the SATA drive bay and then use the
provided mounting screws to secure the drive in place.
SATA drive bay
HDD bracket
Bracket screw
4. Connect one end to the SATA data connector of the SATA drive and the other end to the
SATA data port on the system board. Connect the SATA power connector from the PSU to
the SATA power connector.
Mounting screws
12
Mounting screw
Mounting screw
SATA data connector
SATA power connector
SATA data port
www.dfi.com