Dick SM-200 TE Operating Instructions Manual page 64

Servicing and Maintenance
10
Repeat steps 6, 7 and 8 if the grinding belt does not run in the cor-
rect position.
12 If the belt run is roughly in the correct position, set the switch
The abrasives start up.
13 Now make a fine adjustment to the grinding belt with the belt
14 Set the correct position.
Replace and adjust the wet grinding belt.
10.5 Changing the polishing wheel
Figure 10.7 – Changing the polishing wheel
[1] Polishing wheel
[2] Mounting nut
[3] Flange cover
Change the polishing wheel if the fins are damaged or worn.
SM-200 TE Grinding and Honing Machine
64
for the abrasives to position I (ON).
adjusting screw [2].
- Rotating to the left, the grinding belt moves to the left.
- Rotating to the right, the grinding belt moves to the right.
1
2
3