Dick SM-200 TE Operating Instructions Manual page 13

Safety
• The SM-200 TE grinding and honing machine may only be
operated by people who are familiar with the starting up, oper-
ation, and servicing of machines and the relevant accident pre-
vention regulations, who are able to recognise the hazards
that occur when using the machine and who work reliably.
• The SM-200 TE grinding and honing machine may not be
operated outside the given power ranges (see "Technical
data" on page 19).
• Operate the SM-200 TE grinding and honing machine only
for its approved uses (see "Intended use" on page 11).
Risk of fire in the event of unsuitable environmental influences
Moisture and water can cause a short circuit. Flying sparks can
cause flammable liquids and gases to ignite.
• Do not expose the SM-200 TE grinding and honing machine
to rain or salt water.
• Do not use the SM-200 TE grinding and honing machine near
flammable liquids or gases.
Risk of injury due to damaged or incorrectly mounted machine
parts
Using the SM-200 TE grinding and honing machine with damaged
electric parts or power cables can cause injuries due to electric
shocks or malfunctions. Parts of the damaged grinding wheel, grin-
ding belt or polishing wheel may be spun off the machine.
• Missing or damaged covers expose rotating parts and can
cause injuries due to crushing and drawing in.
Check the grinding and honing machine for damage before
each use, in particular the:
- Grinding wheel,
- Wet grinding belt,
- Polishing wheel,
- Power cable,
WARNING
WARNING
SM-200 TE Grinding and Honing Machine
5
13