Sharpening Knives - Dick SM-200 TE Operating Instructions Manual

Machining Workpieces
The knife can now be ground.
Remove the machine knife from the grinding plate
1 Place the double grinding arm in the grinding lever support
again to remove the machine knife.
2 Open the clamping device of the grinding plate and remove
the knife.
9.3

Sharpening knives

The machine knife is clamped in the grinding plate on the double
grinding arm.
1 Adjust the grinding angle on the grinding device.
2 Lift the workpiece off the grinding wheel with the double grind-
ing arm.
3 Set the On/Off switch for the abrasives to position I (ON).
4 Set the On/Off switch for the cooling water to position I (ON).
5 Lower the workpiece with the double grinding arm. Move the
area to be ground back and forth over the grinding wheel with
light pressure.
Do not stop the movement of the workpiece on the grinding
wheel.
• There is a risk that the knife will overheat and the contour will
be damaged if the workpiece remains stationary on the grin-
ding wheel.
6 Move the workpiece back and forth with the double grinding
lever.
Follow the instructions of the knife manufacturer for grinding work-
pieces.
7 Repeatedly raise the workpiece and check the progress of the
grinding.
8 Complete the process when a burr has formed on the cutting
edge.
SM-200 TE Grinding and Honing Machine
NOTE
NOTE
9
49