Electrical Connection; Performing Test Runs - Dick SM-200 TE Operating Instructions Manual

Putting the Machine into Operation
7
5 Place the cover with the pump back on the water tank.
6 Close the door
Perform steps 2, 3, 4 and 5 for the SM-200 TE grinding and honing
machine without a stand.
7.6
Damage to the SM-200 TE grinding and honing machine due
to mismatching connection data.
•
•
•
1 Before connecting the SM-200 TE grinding and honing
2 Connect the power.
7.7
Perform a test run for the abrasives and for the cooling water unit.
Test run for the abrasives
Check the direction of rotation of the abrasives. The grinding belt
and polishing wheel must rotate in the direction of the arrows for
the direction of rotation on the front of the machine. A second test
run checks the cooling water supply.
1 Press the I (ON) button on the main On/Off switch.
2 Set the switch for the abrasives to position I (ON).
The grinding and honing machine starts up.
3 Check the direction of rotation of the grinding belt and polish-
4 Set the switch for the abrasives to position 0 (OFF).
SM-200 TE Grinding and Honing Machine
30

Electrical connection

Compare the electrical data of the grinding and honing
machine (see "Technical data" on page 19) with the connec-
tion data on site before starting up the machine.
Connect the SM-200 TE grinding and honing machine only to
sockets with a clockwise rotating field and protective earth-
ing.
Connect the machine only when it is switched off.
machine to the mains supply, check that the switches for the
abrasives and for the cooling water pump are set to zero.

Performing test runs

ing wheel.
NOTE