Setting up the Machine
8
Figure 8.1 – Setting the grinding radius
[1] Clamping lever
[2] Universal mounting head
[3] Screw
[4] Extension
[5] Screw
Changing the grinding radius:
1 Loosen the screw [5].
2 Pull the universal mounting head [2] out of the grinding arm.
3 If the extension [4] is required - see table above - insert the
4 If the extension [4] is not required - see table above - insert
5 Tighten the screw [5].
Mounting the universal mounting head [2] on the extension [4]:
1 Insert the pin of the universal mounting head in the extension.
2 Tighten the screw [3].
SM-200 TE Grinding and Honing Machine
42
5
pin of the extension on the right-hand side of the grinding arm.
the universal mounting head [2] on the right-hand side of the
grinding arm.
1
2
3
4