Setting Up Special Solutions For Circular Blades - Dick SM-200 TE Operating Instructions Manual

Setting up the Machine
1 Place the knife edge on the grinding wheel with the double
grinding lever.
2 Raise the grinding arm to the maximum desired angle with the
foot pedal.
3 Check and adjust the contact point if necessary.
4 Loosen the clamping lever of the grinding angle device to
make an adjustment. Move the position of the grinding angle
device forwards or backwards.
5 Retighten the clamping lever or the grinding angle device
once the correct position is achieved.
The touchdown point moves forward a little when grinding smaller
angles.
6 Check the lateral position of the contact point after making this
adjustment. Adjust the lateral position of the contact point if
the position is incorrect here.

8.11 Setting up special solutions for circular blades

Flat circular blades with hole diameters >ø13.5 mm can be sharpe-
ned on the universal and radial grinding arm.
Special accessories are used for sharpening circular blades.
Circular blades have a sharp cutting edge around the circum-
ference. They could cause serious injuries.
• Always wear cut-resistant gloves when working with circular
blades.
• The knives rotate while they are being sharpened.
• Work with due care and attention.
There are a very large number of versions of circular blades. Only
the typical special clamping devices are shown below. Special
clamping devices on request.
WARNING
SM-200 TE Grinding and Honing Machine
NOTE
8
45