Dick SM-200 TE Operating Instructions Manual page 63

Servicing and Maintenance
Replace a worn or damaged grinding belt immediately.
Pull out the mains plug before changing the wet grinding belt on
the grinding and honing machine.
1 Pull out the mains plug on the SM-200 TE.
2 Set the On/Off switch for the abrasives to position 0 (OFF).
If the grinding belt is still running, wait until it stops.
3 Loosen the star handles and remove the belt safety guard.
4 Rotate the belt release lever [3] in the direction of the arrow.
Remove the wet grinding belt [1].
The direction of rotation is marked with arrows on the inside of the
new grinding belt. These arrows must point in the same direction
as the arrow for the direction of rotation on the front of the grinding
and honing machine. The running direction of the grinding belt will
be correct if this is the case.
5 Position the new wet grinding belt.
6 Move the grinding belt on the front roller to the desired posi-
tion. Move the grinding belt a little by hand.
7 Preset the belt run with the belt adjusting screw [2].
- Rotating to the left, the grinding belt moves to the left.
- Rotating to the right, the grinding belt moves to the right.
8 The grinding belt must not run against the guard or the side
panel. The SM-200 TE grinding and honing machine is then
damaged.
If the running direction of the grinding belt is roughly in the correct
position, mount the belt safety guard and fasten it with the star han-
dles.
9 Plug in the mains plug on the SM-200 TE.
10 Move the switch for the abrasives briefly to position I (ON).
11 Check the belt movement when starting up the grinding belt.
The grinding belt must not touch the side panel or belt safety
guard.
SM-200 TE Grinding and Honing Machine
NOTE
10
63