Dressing The Grinding Wheel - Dick SM-200 TE Operating Instructions Manual

Servicing and Maintenance
10
4 Clean the water tank, remove the grinding sludge and replace
5 Lightly lubricate the grinding and honing machine - including
6 Screw the covers on tightly again.

10.2 Dressing the grinding wheel

Clean or smooth dirty or uneven grinding wheels with the dressing
tool.
The dressing tool is supplied with the SM-200 TE grinding and hon-
ing machine.
Figure 10.4 – Dressing the grinding wheel
[1] Dressing tool
[2] Dressing diamond
1 Place the dressing tool [1] on the mounting next to the grind-
2 Tighten the clamping screw on the dressing tool.
•
SM-200 TE Grinding and Honing Machine
60
machine and covers, e.g. with a brush.
the water.
the inside of the covers.
ing wheel.
Before switching on the grinding and honing machine, make
sure that the dressing spindle and the diamond are not tou-
ching the grinding wheel.
NOTE
1
2