Dick SM-200 TE Operating Instructions Manual page 44

Setting up the Machine
8
7 Place the hexagon socket of the double grinding lever on the
8 Mount the clamping lever [1] onto the universal mounting
9 Loosen the locking pin of the double grinding lever.
10 Rotate the grinding plate until the bolt engages.
11 Fasten the grinding plate and double grinding lever to the uni-
Fasten the workpiece in the grinding plate after these initial steps.
Machine knives have a sharp cutting edge. They could cause
serious injuries.
•
•
1 Move the grinding arm to the middle height.
2 Place the double grinding lever in the fork of the grinding lever
3 Lay the knife in the grinding plate and fasten with the rotary
Checking the settings
Check the settings after this work. The contact point of the knife
edge on the grinding wheel should be positioned between 1 o'clock
and 2 o'clock.
SM-200 TE Grinding and Honing Machine
44
shaft of the universal mounting head. Align the hexagon
socket of the double grinding lever with the hexagon head of
the shaft.
head again. Make sure that both hexagon sockets are
threaded.
versal mounting head with the clamping lever [1].
Always wear cut-resistant gloves when working with machine
knives.
Work with due care and attention.
support.
lever of the grinding plate.
WARNING