Table of Contents
Advertisement
2 .
If you do not know your channel setting:
Option 1: Watch the signal strength on your phone inside the building .
(To put your phone in test mode visit www.WilsonElectronics.com or
contact Wilson Electronics Technical Support Team at 866-294-1660 .)
This allows you to read the signal strength from the cell tower . Press
the yellow "CH Select" button until you have the best signal . Refer to
page 5 & 6 on how to read the signal strength from the cell tower .
Option 2: You may also contact your wireless service provider for
optimal channel setting information .
LCD, Uplink & Downlink Directions for 800 MHz
(#807180)
1 .
The Uplink (UL)/Downlink
(DL) gain is displayed on LCD
screen above the knobs . Turn
knob to adjust . Refer to page
13 for Overload information .
2 .
The yellow CH Select
(Channel) button will select the
channel .
3 .
The Uplink (UL) knob limits only
the uplink gain, whereas the
Downlink (DL) knob limits both
the uplink and the downlink
gain . For common settings refer
to chart on page 15 .
4 .
You will typically adjust only the
downlink knob .
5 .
If the Signal Booster is operating normally the LCD Screen will
appear as shown in Figure 3 .
LCD, Uplink & Downlink Directions for 1900 MHz
(#807380)
1 .
Push the yellow "CH Select" button to change the Uplink Center,
Frequency and Bandwidth .
2 .
Pass Bandwidth is the center bottom number . It changes between 5
and 15 MHz each time you press the "Ch Select" button .
3 .
Uplink center frequency is the top number on the screen . It
steps 2 .5 MHz every other time you push the "CH Select" button .
11
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Figure 3
Uplink Gain (dB)
Channel
UL CH DL
70 A 72
800 MHz Channelized
Min
CH
UL
Select
Gain
Max
Mon.- Fri. Hours: 7 am to 6 pm MST.
Downlink Gain (dB)
Min
DL
Gain
Max
Advertisement
Table of Contents
