Outside Antenna Installation - Wilson Electronics 277380 Installation Manual

Cell Tower

Outside Antenna Installation

The antenna should be mounted as shown in the illustration above .
The mounting bracket, included with antenna, is adjustable and will
accommodate pipe diameters from 1 .25" to 2" (pipe sold separately
#901117) . Mount the antenna so that there is at least 3 feet of clearance
in all directions around it . Position the antenna so that it has an
unobstructed line of sight to the cell tower's strongest signal . Make sure
the antenna is not pointing across your own roof or at the Inside Antenna
as this will cause the oscillation protection circuitry to shut down the
Signal Booster .
Warning:
Lightning protection is recommended for all installations
(#859902-50 Ohm shown below) . Take extreme care to ensure
that neither you nor the antenna comes near any electric power line
Installing Lightning Protection
Install the Lightning Surge Protector
(LSP) close to the Signal Booster .
Attach the cable from the Outside
Antenna to the surge protector, using
a short length of low loss cable; attach
one end to the LSP and the other to
the Outside Antenna connector on
the Signal Booster . Ensure the LSP
is properly grounded (ground wire not
included) . LSP sold separately, at
www.WilsonElectronics.com or contact
our sales team at 800-204-4104 .
7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Drip hole on bottom
(sold separately)
Lightning
Surge Protector
(sold separately)
(not included)
To Inside
Antenna
Signal Booster
Surge Protector Power Strip
Mon.- Fri. Hours: 7 am to 6 pm MST.
To Outside
Antenna
Ground Wire
(not included)
To Signal Booster