General Rules; Functional Details - Kranzle LX 2000 Operating Manual

General rules

Oil change
New oil: 1.2 l
Kränzle high-performance transmission oil (Ord. no.: 400932)
or Motor oil 10W40.
Oil leakage
If oil leaks contact your nearest after-sales service (dealer) at once.
(environmental damage, damage to the transmission).
In case of increased humidity or fluctuations in temperature
development of condensed water is possible. If the oil turns
grey
or white, you must change it.
12
The first oil change should be carried out
after approximately 50 operating hours,
then every year or after 250 operating
hours. If the oil turns grey or white, you
must change the oil. In case of exchanging
oil being required, the oil drain screw must
be opened above a container and the high
pressure cleaner be emptied. The oil is to be
caught in the reservoir and disposed of in an
approved manner.

Functional details

High pressure hose and spray device
The high pressure hose and spray device which are part of the LX-series equipment,
are made of high quality material and engineered to conform with the operating
conditions of the high pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void if
spare parts of third-party providers are used! The high pressure hose and
spray device must be connected in a pressure-tight manner
(without leakage).
The high pressure hose may not be driven over, pulled excessively, or
twisted. The high pressure hose may under no circumstances be pulled
over sharp edges. Defective high pressure hoses must not be repaired
(acc. to DIN 20022) but have to be replaced by new hoses approved by
the manufacturer.
Prior to putting the high pressure cleaner into operation make sure
that all safety instructions be observed.
13