Kranzle LX 2000 Operating Manual page 11

Putting into operation
Check the water inlet sieve for damage.
Do not operate the high-pressure cleaner using the damaged filter.
Be careful when using hot water!
When running your high-pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high-pressure
cleaner without safety gloves!
20
9. If using a water inlet filter check it
for cleanliness prior to each startup.
Manually unscrew filter bowl, remove
sieve and thoroughly rinse and clean
with the rest of the parts in clear water.
If the sieve is dirty, water cannot get
through and pressure will not build up.
10. Connect the water hose to water
inlet sieve. The high-pressure cleaner
may be connected to a water mains
(1-10 bar pre-pressure) with either cold
or hot water (up to 60 °C).
The LX-series provides the opportunity
of sucking in water out of a container
(see direct suction).
11. Each time check oil level at the oil
dipstick prior to putting the high
pressure cleaner into operation.
Oil level must be visible in the middle
of the oil sight glass.
Putting into operation
Do not touch the mains plug or any live parts with wet or moist hands.
12. Connect to circuit (see technical data).
The socket must be protected on the
mains side with a 16 A delay fuse
(type C).
13. Switch on high pressure cleaner with
opened safety trigger gun. Bleeding
of the high pressure cleaner: Pull and
release trigger of safety trigger gun
several times. Start cleaning task.
14. Adjust operating pressureinfinitely
using the rotary handle. The maximum
pressure is factory-set.
15. The LX series is equipped with 2 supports
for the trigger gun with safety catch with
lance.
21