Command To Exit Telnet Configuration; Configure Mode; Commands To Configure Wireless Access-Bridge - Zte W200A User Manual

ZXR10 WAS (V1.0) IP Wireless Access System W200A Wireless Access Point User's Manual

5.3.6 Command to Exit TELNET Configuration

Command mode: privileged mode
Function: Exit Telnet and go back to the system
Command format: wlan#exit
Note: This command can only be used via Telnet. If you log in by using a
hyperterminal mode via the serial port, this command will not be available.

5.4 Configure Mode

Mode of entry: Enter the configure terminal command in Privileged Mode
Exit mode: Exit and enter privileged mode
Default prompt: wlan (config) #
Note: In this mode (including the sub-mode), all the configuration commands can be
executed.

5.4.1 Commands to Configure Wireless Access-Bridge

Mode of entry: Enter the access-bridge command in configure mode
1.
mac
2.
access-bridge client connect-server
Command mode: Configure mode
Function: Configure the MAC address of the access bridge connecting the server
Command format: wlan (config) #access-bridge client connect-server mac
Parameter description:
Name Range
MAC address
xx-xx-xx-xx-xx-xx format
access-bridge client enable
Command mode: Configure mode
Function: Enable/disable the wireless bridge client
Command format: wlan( config) #[no] access-bridge client enable
in the MAC address of the access bridge connecting
the server
5-6
Description