Overview; Introduction; Functions And Features - Zte W200A User Manual

2 Overview

This chapter presents the functions, features, technical characteristics and parameters
of W200A.

2.1 Introduction

ZXR10 WAS (V1.0) IP Wireless Access System W200A Wireless Access Point is
developed independently by ZTE CORPORATION. It is designed in full accordance
with relevant international standards. The W200A product can be used to realize single
and multiple access point connections and wireless cellular roaming within a long
range, greatly increasing the work efficiency and providing convenience for the user.

2.2 Functions and Features

W200A can offer connections to the Ethernet via UTP cables at 10/100Mbps, providing
the user with wireless access services. With a wireless network card and proper
network configurations, the user can be connected at a high speed to the LAN and then
the Internet from any place within the effective coverage range allowed by W200A.
Functions and features of W200A include:
Access rate up to 11Mbps; number of access stations up to 100.
Transparent bridging: implementing packet forwarding between Basic Service
Set (BSS) and Distributed System (DS).The maximum forwarding rate is no less
than 10Mbps.
Load balancing: Internal protocols are used to provide balance of multiple APs
at the same place.
Static MAC filtration: Provide filtration of use-specified MAC addresses. Up to
100 filtration groups can be set. Each group can have up to 64 filtration rules.
Version upgrade function: Allows the upgrade of W200A software versions;
remote load of versions on-line is supported.
Built-in SNMP Agent supporting SNMP v1/2c for realizing MIB II,
IEEE802dot11-MIB, IF-MIB, EtherLike-MIB and private MIB.
2-1