Brush Replacement
This table saw is equipped with a universal motor
that uses two carbon brushes to transmit elec-
trical current inside the motor. These brushes
are considered to be regular "wear items" or
"consumables" that will need to be replaced dur-
ing the life of the motor. The frequency of required
replacement is often related to how much the
motor is used and how hard it is pushed.
Replace the carbon brushes (part number:
P0869133-14 for G0869, or P0870133-14 for
G0870) at the same time when the motor no lon-
ger reaches full power, or when the brushes mea-
sure less than
⁄
" long (new brushes are
1
4
Tools Needed:
Standard Screwdriver #2 ................................... 1
Model G0869/G0870 (Mfd. Since 01/19)
To inspect and replace motor brushes:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove brush caps and worn brushes (see
Figure 89) from motor.
Brush Caps
(1 of 2)
⁄
" long).
5
8
Qty
Brush Cap (1 of 2)
Figure 89. Location of motor brushes and brush
3.
Replace both motor brushes and install brush
caps.
Brushes
(1 of 2)
caps.
Motor
-55-