Table of Contents
Advertisement
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Electrical
The electrical components of this saw are not
user-serviceable. This product is double-insu-
lated, which provides protection from electri-
cal shock should a problem ever develop with
grounding.
Great care must be taken whenever servic-
ing double-insulated equipment to make certain
repair does not destroy the insulated properties.
Service should be performed only by or under the
guidance of qualified service personnel.
Cleaning
Cleaning the Model T10824 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off remaining dust with a dry cloth.
Lubrication
All rotating parts within the saw are pre-lubricated
and sealed. Do not attempt to lubricate the saw
or saw blade. The saw requires dry conditions for
proper use.
Blade
Always check saw blade for damage or excessive
wear before each use.
-24-
Brush Replacement
This saw uses two carbon brushes to transmit
electrical current inside the motor. Replace the
carbon brushes when the motor no longer reach-
es full power.
Tools Needed
Flat Head Screwdriver #2 .................................. 1
Replacement brush part number: P10824065
To replace motor brushes:
1.
DISCONNECT SAW FROM POWER!
2.
Using a #2 flat head screw driver, unscrew
front brush cap and carefully remove brush
from motor (see Figure 27).
Front
Figure 27. Motor brush removal.
3.
Unscrew rear brush cap and remove brush
from motor (see Figure 27).
4.
Install new brushes.
5.
Re-install brush caps.
6.
Test run saw to ensure that it is working prop-
erly.
If saw does not start or run properly after
installing new brushes, disconnect it from
power and contact Grizzly Tech Support for
assistance.
Model T10824 (Mfd. Since 07/14)
Qty
Rear
Advertisement
Table of Contents
